(Solved) : Part Two Build Configure Topology Using Packet Tracer Software Based Following Requirement Q35650706 . . .
Part Two: Build and configure the above topology usingPacket Tracer software based on the following requirements.Requirements: To help guide this initial configuration, you’veassembled a list of requirements. 10
1) For addressing the above network use the class C address192.A.B.0 and use it to create networks (subnets) of 2 hosts each.then A = 21 and B =68
2) Enable OSPF routing. Assume all routers are in area 0(backbone)
3) Configure Router R7 with a loopback IP address 7.7.7.7/24.Advertise this network into OSPF process.
4) Don’t forget to configure bandwidth values between links.These values should reflect the costs that are shown in the networkdiagram.
5) If a packet is sent from R1 to R7 (i.e. loopback 7.7.7.7).What routers it passes through until it reaches its destination?Use the traceroute command to test that.
6) Run the show ip route command on R1. From the output result.What is the cost (metric) to get from R1 to R7? Explain that.
7) What is the router-id for R1, and R7? Verify your answers
Given the following topology: R2 R5 Cost -10 Cost 2 Cost 2 Cost-4 Cost 2 R1 R4 R7 Cost 20 Cost 4 Cost 2 R3 Cost-4 Cost 4 R6 Show transcribed image text
Expert Answer
Answer to Part Two Build Configure Topology Using Packet Tracer Software Based Following Requirement Q35650706 . . .
OR